I a fledgling facet guy from Las Vegas and hope to learn a lot from the folks here.
I'm a retired (twelve years) engineer; and amateur astronomer; and a not-so-good-anymore golfer. I'm an active member of the Southern Nevada Mineral & Gem Society... spell that "rock club".
I have a small workshop in my garage with the usual stuff... CabKing, flat lap, trim saw, etc. I recently purchased a Poly-Metric Xrystal-99 from Zane at Poly-Metric, and am just getting used to it. Previous minor facet experience was with a club-owned, old Graves facet machine.
Someday, I hope to be a contributor worth listen to here. Meanwhile, expect a lot of dumb, newbie questions.
Users browsing this forum: No registered users and 11 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum